Phallosan® Forte Device Protocols for Increasing Penis Size, Strength and Potency – COURSE OUTLINE

mecoach phallosan forte penis extender protocolThe Phallosan Forte Device Protocols for Increasing Penis Size, Strength and Potency was developed by expert male enhancement coach, AJ “Big Al” Alfaro, of MaleEnhancementCoach.com.

Use the coupon code — MECOACH5 — at PhalloExtender.com, and you’ll receive $5.00 off your purchase PLUS 2 weeks FREE personalized coaching at meCoach.

Following is the Course Outline section, for this exciting protocol. To visit the other sections of The Phallosan Forte Device Protocol, please visit the Table of Contents.

The Phallosan Forte Device Protocols for Increasing Penis Size, Strength and Potency
COURSE OUTLINE

Before beginning any type of training, please refer to the Disclaimer.

Once you’ve tested yourself, you’ll need to begin adding time and building more endurance. This will take the form of increasing longer sessions and more training frequency.

The below is a sample starter routine for Phallosan® forte device use that covers an entire six-week phase:

Week 1:

  • Day 1 –  TEST DAY- Phallosan® forte device set at .88 lb/.4 kg- tested well at 60 minutes. Tension setting will be at .88 lb/.4 kg until otherwise noted
  • Day 2 –  3 hours
  • Day 3 –  Rest
  • Day 4 –  3 hours and 30 minutes
  • Day 5 –  Rest
  • Day 6 –  4 hours
  • Day 7 –  Rest

Week 2:

  • Day 1 –  4 hours and 30 minutes
  • Day 2 –  5 hours
  • Day 3 –  Rest
  • Day 4 –  5 hours and 30 minutes
  • Day 5 –  Rest
  • Day 6 –  6 hours
  • Day 7 –  Rest

Week 3:

  • Day 1 –  Test day- At this point, an attempt at increasing tension levels to 1.87 lb/.85 kg will be made. Tested well at 60 minutes. Tension setting will now be at 1.87 lb/.85 kg until otherwise noted
  • Day 2 – 4 hours and 30 minutes (Note the time has been reduced to accommodate the new tension settings. This is an internalized version of the “2 steps forward, 1 step back” method)
  • Day 3 –  5 hours
  • Day 4 –  Rest
  • Day 5 –  5 hours and 30 minutes
  • Day 6 –  6 hours
  • Day 7 –  Rest

Week 4:

  • Day 1 –  6 hours and 30 minutes
  • Day 2 –  Rest
  • Day 3 –  7 hours
  • Day 4 –  7 hours and 30 minutes
  • Day 5 –  Rest
  • Day 6 –  Test day- At this point, an attempt at increasing tension levels to 2.43 lb/1.1 kg will be made. Tested well at 60 minutes. Tension setting will now be at 2.43 lb/1.1 kg until otherwise noted
  • Day 7 –  6 hours

Week 5:

  • Day 1 –  6 hours and 30 minutes
  • Day 2 –  7 hours
  • Day 3 –  Rest
  • Day 4 –  7 hours and 30 minutes
  • Day 5 –  8 hours
  • Day 6 –  8 hours and 30 minutes
  • Day 7 –  Rest

Week 6:

  • Day 1 –  9 hours
  • Day 2 –  Test day- At this point, an attempt at increasing tension levels to 3.31 lb/1.5 kg will be made. Tested well at 60 minutes. Tension setting will now be at 3.31 lb/1.5 kg until otherwise noted
  • Day 3 –  7 hours and 30 minutes
  • Day 4 –  Rest
  • Day 5 –  8 hours
  • Day 6 –  8 hours and 30 minutes
  • Day 7 –  9 hours

Week 7:

Rest week

After your rest week, you can either restart the cycle using the “2 steps forward, 1 step back” method, or reassess your training towards another goal. If you had issues during your cycle, it might be best to consult with a Phallosan® forte device for more assistance.

It should be noted the above would constitute a “perfect” progression sequence. It’s possible some trainees might not be able to adapt to 30 minute jumps per session. If you start noticing an overall drop in erection quality and negative side effects, it should indicate smaller jumps in time should be employed.

Another scenario to consider: If you test yourself with a new tension setting and don’t do well, you’d stick with the previous tension setting and continue to add time. Once you build up to training for 3 more hours per session after your test day, another attempt can be made with the previously missed tension setting.

right arrow

Girth Specialization

left arrow

Test Day

Leave a Reply