Announcement

Collapse
No announcement yet.

Can BPEL be wrong?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Can BPEL be wrong?

    I know this is a weird question but I am still worried my BPEL is wrong. My last good measurement was about 7 inch BPEL. I have a large fat pad of around 1.5 to 2 inches and am working to lose it.

    Can BPEL be wrong? Can I be pushing TOO hard and scewing the measurement? It does not hurt when I press in but there is still a lot of pressure. I really find it hard to believe I have 7 inch BPEL....

    I measure along the top of the penis with the numbers down towards the penis.

  • #2
    So long as you are consistent it's the truth.

    Comment


    • #3
      I believe I am. I try my best not to "spine" press. I do have a high pain tolerance so I hope I am not pushing too hard. I figure there is no way I can press past the pelvic bone especially with the ruler turned to the side.

      Comment


      • #4
        Exactly.

        Comment


        • #5
          I do think I do not use my entire BPEL. I know I'd my fatpad was around 1 inch I likely would but in still rocking a 2 inch + fat pad even after loosing 72 pounds. From 347 to 275. Still have a long way to go.

          Comment


          • #6
            Power to your efforts.

            Comment


            • #7
              I am concerned now that I am pressing at the wrong location. I do not do it right against the penis and when I put it right on top it hits the skin attached to my fatpad and hurts and causes me to loose my erection. I place it about .5 inches above it. Is this correct or am I cheating me length?

              Comment


              • #8
                Top of your peen, not back or side and press till you reach the pubic bone. Obviously it'll hurt a little if you press too hard but it's the only way to get an accurate measurement because you're measuring the length of your penis, not your belly.

                If you do it multiple times and get the same measurement, then that is a pretty good indication of your length.

                Comment


                • #9
                  You should be pressing the measuring implement firmly- but not painfully- into your pubis.
                  Want a FREE Month of Coaching? PM or email me for details- or CLICK HERE

                  The MeCoach Male Enhancement Coaching Service- For All of Your Male Enhancement Needs

                  Comment


                  • #10
                    You seem to be geting anxiety about this , which indicates a high level of general anxiety you need to control.

                    Comment


                    • #11
                      Well, I still think your ok in my book.
                      You only want to measure the same way, same erection state, each and every time. Then you'll know when you are making progress with your routine(s).

                      If you mess things up you'll have to buy pizza for us.
                      Valued Member of 11 years at the TheBiohacker
                      Looks are deceiving, mirrors don't lie.

                      Comment


                      • #12
                        I am looking for the correct measurement because I am having a hard time with my quick extender pro. I cannot seem to get it a the correct length. I press in the springs but they never stayed compressed so I feel like my measurement may be off.


                        I have read a lot about this extender and people say it is easy to use. So far I have not find it easy. I still have a lot of pubic fat and I feel like it may be causing issues with this extender.

                        Comment


                        • #13
                          A Penis, when an extenders pulling force or traction, is applied to it, will start to stretch out.

                          That can throw confusion into the mix. Like causing your springs to uncompress. So you have to play the game of adjusting the extenders adjustment screws, adding extra bars, and fastening back in. It can be maddening if you don't realize the mechanics and penis physics going on behind the 'scenes'.
                          Valued Member of 11 years at the TheBiohacker
                          Looks are deceiving, mirrors don't lie.

                          Comment


                          • #14
                            So far so bad. Cant get it on my penis without the springs fully decompressing or my glans will always slip oit. Hope the return policy is not a scam.

                            Comment


                            • #15
                              How big is your fatpad?

                              Comment

                              Working...
                              X