Vac hanging, blister, wrapping

[Alex1988]

SO are you just wearing the vac hanger without pressure or are you under pressure with it?

At first I didn't increase the pressure inside the cap but after a lot of testing I found out that it even works better when I pump just to get a better grip inside the cap. I pump about 2-3 times.

[BigO]

The cool thing is you can attache the compression hanger very lightly on the shaft. It doesn't have to be super tight and still works. Both devices are pushing against each other which makes the magic happen.

Ah, I see. I must admit, I thought you were using it fully under vacuum. SO just enough to basically hold it in place?

I do have all the pieces to do this, just not sure if I am brave enough.

I will follow your progress, hopefully it works out well. I meant no offense with any of my posts.

[DickerSchwanz]

thx Alex, very intriguing. Makes me want to get a Vac finally.

I do have all the pieces to do this, just not sure if I am brave enough.

You could just apply it without weights first.

[Alex1988]

Ah, I see. I must admit, I thought you were using it fully under vacuum. SO just enough to basically hold it in place?

I do have all the pieces to do this, just not sure if I am brave enough.

I will follow your progress, hopefully it works out well. I meant no offense with any of my posts.

Exactly just enough to stay inside the cap and prevent too much slipping.

No worries you did nothing wrong. I know wearing 2 devices that basicaly do the same thing sounds weird. It's hard to explain to people without them having tried it on their own similar to let's say a 60 Hz and a 144 Hz Monitor. Their own eyes have to see it.

[Alex1988]

thx Alex, very intriguing. Makes me want to get a Vac finally.

You could just apply it without weights first.

Hey DickerSchwanz,

I'm looking forward to your extender training results. I just recently started my own extending program and I'm only in my second week. Good luck on your journey.

[Marlon LGHanger]

There's a multitude of ways to protect your glans from blisters while vacuum extending or hanging. I've posted this numerous times, but if you're interested in preventing blisters, then read my blog article.
L.G. Hanger, LLC: Search results for blisters

Here's the way I prefer to wrap. It's been a proven method for me.

1. One piece of microfoam tape across from of glans.
IMG_4619.jpg

2. Then Tender tape - one piece about 7"-8" long. Start wrap 1" below glans, one full revolution, and then wrap in a spiral fashion upwards past glans by about 3/4" - 1".
IMG_4620.jpg

3. Fold Tender tape over front of glans and squeeze / mold to the shape of your penis.
IMG_4621.jpg

We have two widths of blue Tender tape wrap available, along with the microfoam tape.