Headline

This is a draft.


Notes week 356 and 357
Summer vacation. More travel. No PE.

Notes week 358
* Monday morning: Pump, 10 min at 5-6 inHg.
* Monday noon: Pump, 35 min at 5 inHg.
* Monday afternoon: Pump, 30 min at 4-5 inHg.
* Tuesday morning: Pump, 30 min at 5 inHg.
* Wednesday morning: Pump, 30 min at 4-5 inHg.
* Wednesday afternoon: Edging with 44 mm steel ring, 15 min.
* Thursday morning: Pump, ...

Challenging stamina with a fleshlight

My main problem regarding stamina during sex is that when my penis gets squeezed, especially the glans, it feels so much that I am quickly thrown beyound the point of no return.
Having gained a bit of extra girth does not exactly help in this particular area. But I would like to gain more girth...

One way for me to be able to last really long during sex is to apply a numbing spray or cream. This works really fine, especially ...

Started all-day wear of a steel penis ring

I read Jockinthebox's guide to steel cock ring selection (https://www.pegym.com/forums/penis-devices-forum/89410-jockintheboxs-guide-steel-cock-ring-selection.html) and got inspired to also start extended wear of one of those during. I already had a selection of rigid nitril rubber rings of different sizes, so I started to use them around penis an balls during the days in order to figure out which size I should go for.
I quickly found ...

Choosing new condom size

Needed to buy condoms during this period, had not done that for quite a long time and decided to study the subject of condom sizes a bit. Previously I have always bought standard size condoms, and they works for me although I have not followed the instructions. It says that you should start by rolling the condom over the glans and then continue rolling it down the shaft. I have found the first part tricky and have instead unrolled a few centimeters first, stretched ...

Packing the 2 inch cylinder
My 2.25" cylinder got a crack near the top, so it is not holding vacuum so well now. I returned thus to use my older 2.0" cylinder, funny how I now think it is a bit narrow. If I enter it with an erection it is a rather tight fit at the base, that was not the case when I bought it :-)
The timing was good though. When I once again sarted using the 2 inch cylinder I noticed that it was a tighter fit than when I bought it, but it wasn't until the end ...