Hi guys,
I purchased the andropenis extender last week and have been trying to follow the instructions. So I measured at 13cm (5 inches) erect. Instructions said to subtract 4cm and set bars to 9cm. I did that for 5 days, then added 0.5cm as instructed. My problem is that I am having a difficult time gettings the strap to stay under the penis head the way I think its supposed to go. When I remove device, the strap has always ridden up and there is a mark across the penis head. I am using the recommended # of attachments, am putting the rubber ring on penis, then sticking penis through the foam and tightening rubber hoses. Rubber ring and bottom of penis always seem to get pinched a bit when I tighten rubber hoses. Also, my penis is pretty much always sore now. Not sure what I am doing wrong, device is not very comfortable to wear, usually end up loosening it a bit every fifteen minutes or so until eventually penis will pop out and I will have to reset the whole thing. Has anyone experienced these issues? Am I doing something wrong? Do I need to be using rubber ring and foam? Any help would be greatly appreciated, I really want this to work
I purchased the andropenis extender last week and have been trying to follow the instructions. So I measured at 13cm (5 inches) erect. Instructions said to subtract 4cm and set bars to 9cm. I did that for 5 days, then added 0.5cm as instructed. My problem is that I am having a difficult time gettings the strap to stay under the penis head the way I think its supposed to go. When I remove device, the strap has always ridden up and there is a mark across the penis head. I am using the recommended # of attachments, am putting the rubber ring on penis, then sticking penis through the foam and tightening rubber hoses. Rubber ring and bottom of penis always seem to get pinched a bit when I tighten rubber hoses. Also, my penis is pretty much always sore now. Not sure what I am doing wrong, device is not very comfortable to wear, usually end up loosening it a bit every fifteen minutes or so until eventually penis will pop out and I will have to reset the whole thing. Has anyone experienced these issues? Am I doing something wrong? Do I need to be using rubber ring and foam? Any help would be greatly appreciated, I really want this to work
Comment