Results 11 to 17 of 17
- 11-14-2020 #11
- Join Date
- Nov 2020
- Posts
- 41
There were no cushins in mine,i have to buy seperatly
- 11-27-2020 #12
- Join Date
- Oct 2020
- Location
- Sweden
- Posts
- 71
Last edited by Matthewxxx; 11-27-2020 at 04:06 PM.
20.10.12: 19.5 x 14.0 cm
Goals
22.10.12: 21.0 x 16.0 cm
26.10.12: 23.0 x 18.0 cm
- 11-27-2020 #13
I use a different tape but can confirm that a tight fit in the chamber is paramount to hanging heavy weight in a vacuum hanger.
I use the LG but the same fit applies.
I tape up, then go into chamber and pump. I do not put weights on hanger until I have been in for a few minutes, This allows my glans to expand and fill the chamber before weights are applied.
I have not gone to 20lbs but I believe that I could with no issues. I have made it to 15 but I was also wearing my hanger for sometimes up to 2 hours at a time so I didn't need more weight.Going an inch and 1/2 deeper than before
- 11-27-2020 #14
- 11-27-2020 #15
- Join Date
- Jul 2018
- Posts
- 392
I don’t own either one, so take my opinion with a grain of salt.
I really like the looks of the TOTALMAN kit.
After your hang session, go to the ADS and on with your day.
Replacement parts look available also.
I also prefer vac/bell setups, especially with an extender.
The length master looks a little cumbersome.
I have a toy box already, but would consider the TOTALMAN if I was on the market.
Stay safe and enjoy!
Stay
- 11-27-2020 #16
After looking at both online, I think the length master looks to be of far better quality. I can make something like that in my garage, may not be as refined but it is a leverage device with a clamp attachment, pretty simple to make with a couple pieces of lumber and some hardware.
I will make one this coming week, it looks like it would get some good torque, best be careful though, don't want to pull it out at the root!Going an inch and 1/2 deeper than before
- 11-28-2020 #17
- Join Date
- Oct 2020
- Location
- Sweden
- Posts
- 71
I can say that I also...
Procedure for using andropenis so...