Results 1 to 4 of 4
- 01-03-2021 #1
- Join Date
- Jan 2021
- Posts
- 2
I've bought andropenis set maybe 8 months ago, sensing opportunity when the initial lock down happened.
I attempted to follow their instructions though they leave a lot to be desired and had pretty bad results so far.
First time I wore it for less than an hour, after the sesh my dick was half dead so I went for a run to get circulation back on all whilst freaking out. Tried it maybe few times more afterwards and then gave up.
It seems each time the silicon ring slips and rather than being situated beneath the glans it ends up strangling my head going halfway across it.
To mediate that I tried:
1) Washing the silicon ring (though I doubt there would be any oil residue after few uses)
2) Decreased the starting rod height derived from the manual by an extra 0.5 cm (i do feel tension but in the head...)
3) Made sure to pull foreskin all the way down once the ring is on so that the silicon ring rests on glans only and not the spare skin
Haven't really had any more success with these approaches. I tried again today (after a long hiatus), and ended up checking on it to see if I feel pressure still every few minutes and then too it off after half an hour to discover the ring has again slipped and was resting in a weird diagonal position across the head then gave up for the remainder 30mins.
Hard for me to not get slightly hypochondriac, as I can't really feel the ring slipping it's just when I take it of dick is kind of malformed in a weird way and won't work properly for few minutes. Realistically I know there shouldn't be much to worry and that the dick can be subjected to far more stress without any negative or permanent reaction, it's still hard to keep these notions out of your head.
I've read of people suggesting to use gauzes, not sure if they were instead of the ring which might make sense as their friction index would be higher or along with it. Any other tips how to apply this device properly, or how to ensure that the hold is applied uniformly through the ring or otherwise I'd be grateful.
- 01-14-2021 #2
Member of the Month Sept 2017
PEGym Hero
- Join Date
- Jun 2015
- Location
- South Korea
- Posts
- 4,405
Did you do a search for related posts?
03/2015 Start <Able to last ~ 2 mins PIV>
Thread
12/2019 EL: +2.2 MEG: +1 <Able to last 60+ mins PIV>
- 01-20-2021 #3
- Join Date
- Jan 2021
- Posts
- 2
I did yeah, though not sure if I came across every single one. I'm not sure if there is a page summarising them or a separate sub-forum for either adnor or slippage, I've found articles relating to my issue through google searches only.
Do you have any tips yourself either on application or finding the right resources?
- 01-24-2021 #4
- Join Date
- Oct 2020
- Posts
- 14
I can say that I also struggle with the same problem. I am using all 3 things you mentioned. I also tried with balooning and that is the only thing that shows some success to me. Also, the silicone bands start to erode after 2 weeks.. they loose a bit of volume due to constant extension ..and they do not hold glance so well anymore. So i have to change silicone band every 2 weeks and put the new one.
05/03/2021 - My Journey to 8...
ProGasmDave Progress Log