Results 11 to 14 of 14
Thread: Bathmate suction mat?
- 02-26-2021 #11
Burrito, I was considering doing the same but with a silicone pad to keep a tight seal with the pump. I use an air pump though, so not sure about the bathmate. Flexibility was another reason for wanting silicone... the hole would be tight enough to act as a cockring but still have some give so it's not too tight. I've got some silicone cupcake baking pans that I've been meaning to defile but keep forgetting about. haha. Maybe I'll give them a go.
- 03-04-2021 #12
Mutilated the silicone cupcake pan and pumped with it today. Got lucky and made it the perfect size. I only used it for a few minutes and up to -5 Hg at the beginning of my session. I think the results would be similar with the bathmate vs. air pump. What I found:
1. No ball suck.
2. Good seal.
3. My air pump didn't pull into my fat pad and I don't think it would have much at more pressure. Also, I don't think I would have felt like my spermatic cords were getting crushed or sucked into the tube either.
Overall though, there just wasn't enough pulled into the pump to allow for much internal tissue stretch. I should have been 1" longer inside the tube. This might be a good way to isolate the tunica though?Last edited by tank0909; 03-04-2021 at 11:37 AM.
- 03-04-2021 #13
Member of the Month Oct 2017
PEGym Hero
- Join Date
- Jun 2017
- Location
- Surrounded by peaches
- Posts
- 6,632
- Blog Entries
- 1
Very interesting findings! I'll be experimenting myself soon. Silicone pad seems like a viable option. My concern with a foam mat was it being too porous and leaking air.
PE smarter, not harder brah
Progress Log | Extender Progress Log
Recommended Routine | Dating Advice
Homemade Power Jelqer - How to
2016 (5 1/2 x 4 1/2) > 2017 (7 5/8 x 5 5/8) > Jan 2020 (7 3/4 x 5 3/4) > Sept 2020 (8 x 5 3/4)
BPEL Gains: 2.5" | MEG Gains: 1 1/4"
- 03-04-2021 #14
I think a flat silicone pad may have slightly better results, if there's any difference at all. Yeah, that makes sense with the foam. Plus it's not stretchy at all so after a good pump you may have to destroy it to get it off. haha. I thought I'd need a thicker layer of silicone, but what I had worked just fine. Looks like 1mm thick, holding the cutout to a ruler... a little thicker may be better.
Also, how do I know I’m not...
Very disappointed and disheartened...