REP Support for X4 Labs Penis Extender - Q & A

[afilho]

Hi afilho,

Sorry to hear you are having issues wearing your Deluxe Edition penis extender. Generally, there is a learning curve involved when you are first getting used to putting on and wearing your device. I am sure you will get the hang of it.

In order to wear a standard device, you must be 4 inches flaccid. If you are below that, you need to get the Quad (Mini) Support piece which will reduce the amount of stretching required for you to reach the support. The Quad is designed to fit sizes as low as 1 inch flaccid!

I know if you call in between 9 am to 5 pm one of our representatives would offer you that piece at a reduced price if you think it would help.

Tightening the strap is easy, simply pull the two ends that are hanging below the extender device support piece. And to remove it, pull the two tabs at the top.

I hope this helps, I am just trying to give you a reply with what little information I have. If you can elaborate, I can assist further.

Thanks!

It's funny that i couldn't know before i purchased about this Quad (Mini) Support! Now i have to spend more money? What are you guys thinking? If i knew my penis wouldn't wear it i'd never buy it!

[mrimalive1]

I figured out what a lot of people are doing wrong! You have to make sure that your glands are past the end of the extender when your are done righting it! So when measuring do not count your penis head as part of the length! Only the shaft, then you will know what extensions you should be at.

[sergio16]

Hi x4labs,

Just wondering where I can find a solid routine for my extending? I only recently received the extender, haven't really started wearing it because I don't know where to start i.e. how much tension to use and for how long each time during the first week? etc.

Thanks

[mrimalive1]

Is it normal for my glans to become sensitive. Since starting I have noticed they are more sensitive now

[X4Labs]

Hi x4labs,

Just wondering where I can find a solid routine for my extending? I only recently received the extender, haven't really started wearing it because I don't know where to start i.e. how much tension to use and for how long each time during the first week? etc.

Thanks

Hi sergio,

Thanks for your question. I hope answering it will help you and many PEGYM users down the line as well. Penile traction therapy (also known as penis extending) can be done successfully with many different routines. Which is a good thing when you think about it, because we all tend to have different time constraints.

Generally what you want to do is wear your device between 4-8 hours per day, every day, taking periodic breaks when you feel any sign of discomfort. That would equal between 28-49 hours every week. Using this type of routine will yield optimal results in 6 months time.

That is a lot to ask for some people, but there is some good news. That routine can be adjusted to fit your lifestyle. While we would not recommend wearing your device more than that, many users have reported great results in our clinical studies with less frequent use. Many users opt to take 2-3 days a week off for recovery. This is fine, as long as you still manage to stay consistent and understand that it will take a longer time frame to get optimal results. Other users wear the device every day but for shorter periods of time, which has the same result as taking off days.

As far as what to do within your sessions, when you start, go easy. Adjust the configurations to find a good fit with moderate tension. Comfort is the key. Once you feel you have the best fit for your shape and size, slowly increase the tension as you go. You will see that you will get more and more accustomed to it and adding tension will not create much, if any discomfort.

Also, don't shy away from taking 20-30 minute breaks within sessions. As you go, the desire to do so will lessen over time. You will notice that after 2-3 months of a steady routine you virtually no longer feel the desire to take any breaks at all.

Another extremely useful idea is to track your usage. Keep record, jot down how many hours you've worn your device, and take weekly measurements of your progress. This will keep you motivated and give you a good idea of how many hours you have completed and how much length and girth you have gained.

Thanks, and please feel free to hit me up with any other questions you have.

[X4Labs]

It's funny that i couldn't know before i purchased about this Quad (Mini) Support! Now i have to spend more money? What are you guys thinking? If i knew my penis wouldn't wear it i'd never buy it!

Hi afihlo,

You have my apologies for any sizing issues you may be experiencing. For what it is worth, I would like to take a moment to stress how important it is to be aware that your device will be a good fit prior to buying it. Many users aren't fully aware of how important and revolutionary the Quad Support piece is. Not only does it dip closer to the base for those under 4 inches, but it also allows double fastener support and more stability for the average size and above.

If you would like, message customer support with your issue and I am sure we will do the best we can to get you a Quad Support Piece at a reduced cost. Simply mention our discussion on PEGYM in your message or phone call.

Thanks.

[X4Labs]

Hi meimalive1,

Thanks for all your questions and comments, I will go over them and reply one by one for you.

I have purchased the Delux edition. Hopefully this does help me gain some length. I really just don't have the time to do length and girth. I will be doing my girth routing to wear down my tunica, then slapping this bad boy on to stretch it out. I remember all the times big al told me to wear your shaft down with girth work then stretch it.

The beauty about penile traction therapy, and what many users and even potential users don't realize is that it can increase both your length and girth proportionately. When we ask for measurements with our clinical studies, we always as for both length and girth measurements and I am glad to say that the results in girth growth rival that of length in nearly all cases.

Ok so I have a issue. I don't know where to start with the along atom bars. I tried the 2 inch ones and I still see all 3 of the tension lines. Then I added the .5 inch Rods and My stretched flaccid couldn't reach it. What to do what to do?

The tension lines are not as important as feeling the tension on your shaft. Remember you can always unscrew the spring bars from the base, which makes the support piece extended further out which in turn increases tension. May also help to order some smaller bars, I tend to prefer using smaller bars myself because they allow me to adjust the overall size of the device in smaller increments.

I figured out what a lot of people are doing wrong! You have to make sure that your glands are past the end of the extender when your are done righting it! So when measuring do not count your penis head as part of the length! Only the shaft, then you will know what extensions you should be at.

That is true to a certain extent. You want to have your fastener secured just behind your glands to increase the stability of your configuration. That way when your device springs expand, you don't slowly slip out. The Quad Support Piece really helps with that as it allows you to evenly distribute that stability between two fasteners of your choice. It really goes a long way in eliminating slippage.

Is it normal for my glans to become sensitive. Since starting I have noticed they are more sensitive now

This is a common affect for those of us when we first begin traction therapy. This effect tends to go away once you become more used to it but for the time being I strongly recommend taking periodic breaks. You will notice that the sensitivity will lessen over time.

Hope these answers help, feel free to follow up with any other questions or comments you may have. Thanks.

[mrimalive1]

Thanks for the reply! They are still sensitive but it's not a total bad thing. Now during sex it add a lot more pleasure for me. Now I don't want them going back to not being sensitive!

[mrimalive1]

One more thing. I have a really bad pinch feeling after about 40 mins in the extender with my forskin pulled back. If I wrap with my forskin over there glands I don't get this problem and I can stay in the device for a longer period of time. So far longest time with forskin not retracted 2.30 hrs. With it retracted I can only get like 50 minutes. Maybe I just have way to much extra skin.

[X4Labs]

One more thing. I have a really bad pinch feeling after about 40 mins in the extender with my forskin pulled back. If I wrap with my forskin over there glands I don't get this problem and I can stay in the device for a longer period of time. So far longest time with forskin not retracted 2.30 hrs. With it retracted I can only get like 50 minutes. Maybe I just have way to much extra skin.

Hi mrimalive1,

We are well aware that everyone has a different shape and size and do our best to provide a comfortable experience for every one of our users. If you are feeling a pinch, you should take a break, to avoid causing any irritation. Perhaps you should try a different configuration that will allow your foreskin to stay un-retracted and yet still get the same traction.

The key is to feel traction along the shaft of your penis, but not at the expense of comfort. I strongly recommend you try different setups to find one that works well for you.

Have you tried any other configurations? What setup are you currently using? Let me know and I can make suggestions.

Thanks.