air pump questions

[mrmagoo2010]

when you guys say pump to 5hg, do you mean start at 0, pump to 5hg, and leave it for 20 minutes? I notice the pressure slowly drops, do I then pump back to 5hg and maintain it there? or should it stay at 5hg?

Also, I have 1 3/4 inch cyclinder, and dont pack it, maybe bottom quarter, will I be able to pack it over time? does this mean penis is growing when I can pack rest?

[MrB8]

Pump to 5hg and when you get a good seal start your timer, 10 to 15 minutes is a good session for starters.

Trim your pubic hair and use lube.

[kickinthemebs]

Yes, pump it back up to 5 h.g. when it drops is what we mean. Yes, you will be able to pack it over time.

[Looking4more]

The pressure will drop slowly unless you have a really good seal. Like MrB8 pointed out, lube and trimming surely helps. I have found I need to give it a slight pump once or twice in a session but that's all.

[needtogrow4]

I have then same problem. It seems to suck up some of my turkey neck and when I pump to 5 sometimes my balls get sucked but to the pump making it uncomfortable. I can never get a good enough seal to maintain 4-5hg even though I trimmed and use lube. I do a pump every 30 seconds to a minute. Is that too often?

[Zman007]

I have then same problem. It seems to suck up some of my turkey neck and when I pump to 5 sometimes my balls get sucked but to the pump making it uncomfortable. I can never get a good enough seal to maintain 4-5hg even though I trimmed and use lube. I do a pump every 30 seconds to a minute. Is that too often?

What is your base girth and what size tube are you using?

i also pull my balls and turkey neck down before puttin the pump on and giving good inward pressure before pumping. I've been getting pretty good seals even if I don't use Lube.

[not2big]

You should not need to pump every thirty seconds to maintain the vacuum level at 5 hg. As the others have said, you should only need to pump once or twice during a twenty minute session to maintain the 5 hg vacuum as your dick becomes a bit further enlarged due to fluid build up in the cells.

If you need to pump more often, you either have a bad seal or your cylinder/valve is leaking.

[needtogrow4]

Base girth is 4.4-4.5 and I'm also using the 1.75 inch cylinder. How could I get a better seal?

[MrB8]

Use a 1.5" cylinder.

Base Girth --> Cylinder Diameter
3.50 to 4.50* --> 1.50
4.75 to 5.25* --> 1.75
5.50 to 6.00* --> 2.00
6.25 to 6.75* --> 2.25
7.00 to 7.50* --> 2.50
7.75 to 8.25* --> 2.75

...

i started with a mid shaft girth of 4.4" and took six months before I started to pack my 1.5" round cylinder.

[not2big]

PumpToys offers a VelSeal top quality gasket that improves the seal, prevents ball suck in and significantly improves comfort. However, it costs $29 and fits cylinders that are either flanged or flared at the base. I am still using my first gasket after four years of pumping though I had to buy a larger one after my third cylinder upgrade.