How do you measure girth?

[wind chill]

let's hear it.

[redbear52]

Using a tape measure except at the base where scrotal skin can get in the way, where I use a string, mark it, and measure between marks on a ruler. I usually measure at the glans (in a plane perpendicular to the axis of the penis, at the mid shaft, and at the base.

[going411by7]

Same here. My base and glans are identical in girth, so it really doesn't matter that much. Why not measure at the thickest part? I would.

[Danner]

I use my midshaft for my girth since it will not make difference from my base it is the same. 5.5'' But if my base was bigger I would use that instead for sure.

[Midnight Man]

As you can see from my sig, I measure just below the glans, mid-shaft and at the base. I then take the mean of those three. I'm quite happy with the way my girth is distributed, getting thicker as it goes down the shaft. I hope hope any gains I make don't change these proportions.

[NP97]

I measure just below the glans, the middle, and the base and take the average. If someone asks how big it is... I'll give them the midshaft.

[mika]

I fully agree with you guys. At least 3 measurements along shaft. From my practice and volume calculations in most cases including glans girth to the average makes it even more accurate. So, base, midshaft, just below glans and glans

[blink2000]

I only use MSEG... I gained 1" of base girth from hanging, but I don't count it at all.

My wife of course still gets to enjoy the benefit of the extra girth... so it counts that way.

I guess I had the impression that including my base measurements was "cheating"; now I'm realizing that idea was silly--now that I'm consciously thinking & writing about this...

An average would definitely be more accurate (base, mid, and top) -- I agree with you guys too.

[Stretch Armstrong]

mid-shaft.. same spot each time.

[Pedowolf]

Midshaft since it's same as base